Specifications

Chapter 4 Configuration Installation and Operation Manual
4-10 Configuring IPmux-24 for Management IPmux-24 Ver. 1.5
IPmux-24
Configuration>System>Management> SNMPv3 Settings> Target & Notify > Trap
1. Tag Name >()
2. Trap >()
>
ESC-prev.menu; !-main menu; &-exit 1 Mngr/s
Figure 4-10. Trap Menu
Configuring Target Parameters
Target is an SNMPv3 network management station to which IPmux-24 is going to
send trap notifications. A set of parameters has to be configured and assigned to
each target.
³ To configure target parameters:
1. From the Targets & Notify menu (Configuration > System > Management >
SNMPv3 Settings > Targets & Notify), select Target Params.
The Target Params menu is displayed (see
Figure 4-11).
2. From the Target Params menu, configure the following:
 Name (An ASCII string identifying current set of target parameters)
 Message Processing Model (The Message Processing Model to be used
when generating SNMP messages using this entry):
 SNMPv1
 SNMPv2c
 SNMPv3
 Security Model (The Security Model to be used when generating SNMP
messages using this entry):
 Any
 SNMPv1
 SNMPv2c
 User-Based Security Model (USM)
 Security Name (Identification of the principal on whose behalf SNMP
messages are to be generated using this entry. This can be either
SNMPv3 user or SNMPv1/SNMPv2 community string.)
 Security Level (The level of security to be used when generating SNMP
messages using this entry):
 noAuthNoPriv (Authorization and privacy are disabled)
 authNoPriv (Authorization is enabled, privacy is disabled)
 authPriv (Authorization and privacy are enabled)