Specifications

Chapter 4 Configuration Installation and Operation Manual
4-8 Configuring IPmux-24 for Management IPmux-24 Ver. 1.5
IPmux-24
Configuration>System>Management>SNMPv3 Settings
Engine Boots (2)
Engine Time (276)
SNMP Message Size ... (1500)
1. Users >
2. Targets & Notify >
3. SNMPv1/v3 Mapping >
4. SNMPv3 Factory Defaults
5. Summary Target Table []
6. Summary User Table []
>
ESC-prev.menu; !-main menu; &-exit 1 Mngr/s
Figure 4-8. SNMPv3 Settings Menu
Adding SNMPv3 Users
IPmux-24 supports up to ten SNMPv3 managers with different authorization and
privacy attributes.
Access control policy is defined via the vacmSecurityToGroupTable and
vacmAccessTable tables, which can be accessed via an SNMP browser only.
³ To add an SNMPv3 user:
1. From the Users menu (Configuration > System > Management > SNMPv3
Settings > Users), perform the following:
 Select Security Name and enter security name for a new user (up to 32
alphanumeric characters).
 Select Authentication Protocol and define the authentication protocol to
be used for authenticating the user:
 usmNoAuthProtocol (No authentication is performed)
 usmHMACMD5AuthProtocol (MD5 protocol)
 usmHMACSHAAuthProtocol (SHA protocol)
 Select Privacy Protocol and define the type of privacy protocol to be used
for encryption:
 usmNoPrivProtocol (Privacy protocol is not used)
 usmDESPrivProtocol (DES protocol)
 Select Authentication Password (eight characters) and define the
authentication password of the user. This is not available if
authentication has been disabled.
 Select Privacy Password (eight characters) and define the private key
used for encryption. This is not available if privacy has been disabled.
Note