Specifications

Chapter 4 Configuration Installation and Operation Manual
4-6 Configuring IPmux-24 for Management IPmux-24 Ver. 1.5
³ To remove a network manager:
1. From the Manager List, select a network manager that you intend to remove.
2. Type r to remove the selected network manager from the list.
³ To clear the manager list:
• From the Manager List, type c to delete all network managers.
Configuration>System>Management>Manager List
Manager ID IP Address IP mask Trap mask
1 172.18.159.35 255.255.255.0 Disable
1. Change cell ... (172.18.159.35)
A – add R – remove C – clear table
ESC-prev.menu; !-main menu; &-exit; ?-help
Figure 4-5. Manager List Menu
Configuration>System> Management > Manager List
Manager ID (1)
1. IP Address ... (0.0.0.0)
2. IP mask ... (0.0.0.0)
3. Trap Mask ... (Disable)
>
ESC-prev.menu; !-main menu; &-exit 1 Mngr/s
Figure 4-6. Manager List Menu, Add Mode
Configuring SNMPv3
IPmux-24 supports SNMP version 3 entity, providing secure access to the device
by authenticating and encrypting packets transmitted over the network.
Follow these steps to configure the SNMPv3 entity:
1. Define SNMP engine ID
2. Enable SNMPv3.
3. Add a new user or use a default user account.
4. Add a new notification entry.
5. Assign traps to notification entries.
6. Configure target (NMS) parameters.
7. Specify target address, define its parameter set and assign notification tags.
8. Map SNMPv3 setting to SNMPv1 settings. This is necessary for coexistence of
different SNMP versions. For example, when managing an SNMPv3 agent via
an SNMPv1 NMS.