Specifications

IPmux-24 Ver. 1.5 Configuring IPmux-24 for Management 4-1
Chapter 4
Configuration
This chapter illustrates the configuration IPmux-24 screens and explains their
parameters.
Menu trees of the IPmux-24 management software are shown in
Chapter 3 .
4.1 Configuring IPmux-24 for Management
Usually, initial configuration of the management parameters is performed via
ASCII terminal. Once the IPmux-24 host IP parameters are set, it is possible to
access it via Telnet, Web terminal or RADview for operation configuration.
Perform the following steps in order to configure IPmux-24 for management:
³ To configure IPmux-24 for management:
1. Connect an ASCII terminal to the RS-232 control port of IPmux-24.
2. Log in as Superuser (su).
3. Enable or disable the IPmux-24 DHCP client.
4. Assign an IP address to IPmux-24.
5. Assign a subnet mask and a default gateway.
6. Configure the SNMP communities.
7. Set a manager IP address.
Make sure that you save your settings at each configuration screen.
Configuring IP Host Parameters
IPmux-24 can be managed by a network management station, which is located on
the LAN connected to the one of the unit’s Ethernet ports. In order to establish a
proper connection, it is necessary to configure the following: host IP address,
subnet mask, default gateway, its trap, read and write communities. In addition,
you can enable or disable DHCP client of the device.
Note