Specifications

Chapter 2 Installation and Setup Installation and Operation Manual
2-2 Mounting the Unit IPmux-24 Ver. 1.5
• RM-35/P1 rack mount kit for mounting one IPmux-24 unit (if ordered)
• RM-35/P2 rack mount kit for mounting two IPmux-24 units (if ordered)
• WM-35 wall mount kit for IPmux-24 (if ordered).
2.4 Equipment Needed
IPmux-24 is a standalone unit, designed for desktop or bench installation and is
delivered fully assembled. No provisions are made for bolting the unit to a
tabletop.
Mounting IPmux-24 in a 19-inch rack, however, requires a 3 mm Phillips
screwdriver and an RM-35 kit. For the rack installation instructions, refer to the
Rack Mounting Kit for 19-inch Racks
guide that comes with the RM kit.
Power Cable
AC-powered IPmux-24 is equipped with an appropriate power cord (country or
region dependent) to be connected from the mains to the power socket of the
hot-swappable power unit.
DC-powered IPmux-24 is equipped with an appropriate DC connection kit, which
should be used for preparing the DC cable connection.
Interface Cables
Refer to the following table to determine what cables and connectors are
required for installation.
Appendix A specifies the wiring of all connector pinouts.
Table 2-1. Required Interface Cables
Interface Cable Type
Control terminal DB-9 to DB-9, RS-232/V.24 compliant cable for
ASCII-based terminal control
Ethernet • Electrical: Cat. 5, RJ-45 to RJ-45, IEEE 802.3 compliant
cable
• Fiber optic: Fiber optic cable that matches the
ordered interface type.
E1/T1 • Balanced: Cat. 5, RJ-45 to RJ-45 cable
• Unbalanced: CBL-RJ45/2BNC/E1/X adapter cable
2.5 Mounting the Unit
IPmux-24 is designed for installation as a desktop unit. It can also be mounted in
a 19" rack or on a wall.