Specifications

IPmux-24 Ver. 1.5 Configuring IPmux-24 1
Quick Start Guide
Installation of IPmux-24 should be carried out only by an experienced technician.
If you are familiar with IPmux-24, use this guide to prepare the unit for operation.
1. Installing IPmux-24
Connecting the Interfaces
1. Connect the network interface to the connector designated ETH 1.
2. Connect the user LAN(s) to the connector(s) designated ETH 2 or ETH 3.
3. Connect the E1 or T1 lines to the RJ-45 connectors designated E1 or T1.
When connecting balanced E1 or T1 equipment, make sure to use only 4-wire
RJ-45 connectors with the following pins used for receiving and transmitting data:
1, 2, 4, 5. Do not use 8-pin RJ-45 connectors.
4. Connect the control terminal to the rear panel CONTROL connector.
or
Connect a Telnet host, or a PC running a Web browsing application to one of
the user LAN ports.
Connecting the Power
• Connect the power cable to the power connector on the IPmux-24 rear panel.
The unit has no power switch. Operation starts when the power is
applied to the rear panel power connector.
2. Configuring IPmux-24
Configure IPmux-24 to the desired operation mode via an ASCII terminal connected
to the rear panel CONTROL port. Alternatively, you can manage IPmux-24 over
Telnet, or via a PC running a Web browsing application connected to one of the user
LAN ports.
Caution