Specifications

Installation and Operation Manual Appendix B Boot Sequence and Downloading Software
IPmux-24 Ver. 1.5 Downloading the Application and Configuration Software B-3
5. Send the software release file to IPmux-24 using the XMODEM utility of you
terminal application.
Once the downloading is completed, IPmux-24 saves the new release as an
active partition, the former active partition turns into backup, and the boot
sequence continues normally.
If a failure occurs during the download, the partially downloaded software is
erased. In this case, only active software is left in the flash memory.
Downloading Application Files via TFTP
³ To download application file via TFTP:
1. From the Boot Manager menu, select System Configuration.
2. Configure the IP parameters of IPmux-24 (IP address, IP mask and default
gateway). These parameters are valid only for the TFTP file transfer via the
Boot Manager.
3. Select Reset Board to reset the unit.
4. Start a TFTP application.
5. Select a local software release file to download.
6. Enter the IP address of the TFTP server.
7. Start downloading.
IPmux-24 automatically erases the backup partition (it takes about
25 seconds). Once the downloading is completed, IPmux-24 saves the new
release as an active partition, the former active partition turns into backup.