Specifications

Chapter 6 Diagnostics and Troubleshooting Installation and Operation Manual
6-22 Testing IPmux-24 IPmux-24 Ver. 1.5
Diagnostics>Ping
1. Interface (PW Host IP)
2. Destination IP address ... (0.0.0.0)
3. VLAN tagging (Enable)
4. VLAN ID[1 - 4095] ... (0)
5. VLAN priority[0 - 7] ... (0)
6. Number of frames to send[1 - 4] ... (1)
7. Ping Send
>
Please select item <1 to 6>
ESC-prev.menu; !-main menu; &-exit 1 Mngr/s
Figure 6-18. Ping Menu
Running a Trace Route
You can run a trace route to a remote IP host to check the IPmux-24 IP
connectivity.
³ To run a trace route to an IP host:
1. From the Diagnostics menu (
Figure 6-5 ), select Trace route.
The Trace route menu appears (see
Figure 6-19 ).
2. From the Trace route menu, configure the following:
 Destination IP Address (IP address of the host to which you intend to
trace the route): 0.0.0.0 to 255.255.255.255.
 VLAN Tagging:
 Enable (VLAN tagging is enabled)
 Disable (VLAN tagging is disabled)
 VLAN ID: 1–4095
 VLAN Priority: 0–7
The VLAN ID and VLAN Priority configuration is available only if the VLAN tagging
is enabled.
3. Select Trace route send to start the trace route.
Note