Specifications

Installation and Operation Manual Chapter 6 Diagnostics and Troubleshooting
IPmux-24 Ver. 1.5 Testing IPmux-24 6-21
Diagnostics>Loopback (T1)>Inband Loop Detection
1. Loop Location > (Local System)
2. Loop up length[1 - 8] ... (5)
3. Loop up code[Hex] ... (10)
4. Loop down length[1 - 8] ... (3)
5. Loop down code[Hex] ... (4)
>
Please select item <1 to 5>
ESC-prev.menu; !-main menu; &-exit 1 Mngr/s
Figure 6-17. Inband Loop Detection Menu
Pinging IP Hosts
You can ping remote IP host to check the IPmux-24 IP connectivity.
³ To ping an IP host:
1. From the Diagnostics menu (
Figure 6-5 ), select Ping.
The Ping menu appears (see
Figure 6-18 ).
2. From the Ping menu, configure the following:
 Interface (Direction (switch port), to which the ping is sent):
 System host IP (IPmux-24 sends ping to an IP address in the
management subnet)
 PW host IP (IPmux-24 sends ping to an IP address in the PW traffic
subnet)
 Destination IP Address (IP address of the host that you intend to ping):
0.0.0.0 to 255.255.255.255.
 VLAN Tagging:
 Enable (VLAN tagging is enabled)
 Disable (VLAN tagging is disabled)
 VLAN ID: 1–4095
 VLAN Priority: 0–7
The VLAN ID and VLAN Priority configuration is available only if the VLAN tagging
is enabled.
 Number of frames to send: 1–4.
3. Select Ping Send to start sending pings.
Note