Specifications

Installation and Operation Manual Chapter 5 Configuring IPmux-24 for Typical Applications
IPmux-24 Ver. 1.5 Typical Pseudowire Application with Ring Protection 5-11
Configuring the Bridge
Refer to the Configuring the Bridge section above for instruction on how to set
the bridge to the VLAN-aware mode.
Configuring the VLAN Membership
Both network ports of each IPmux-24 must be egress tagged members of the
same VLAN 100 (ring VLAN). In addition
³ To configure the VLAN Membership:
• From the VLAN Membership menu (Configuration > Bridge > VLAN
Membership), set the IPmux-24 network ports to be tagged members of VLAN
100:
1. Type a to invoke the Add mode.
2. In the Add mode, set VLAN ID to 100.
3. Save the changes.
4. Select Egress Tagged Ports and type a to invoke the Add mode.
5. In the Add mode, set Egress Tagged Port to 1 and 2.
6. Display the management host VLAN (VLAN ID 5), and add port 3 of IPmux-24
(A) as its egress tagged member as well.
Configuration>Bridge>Vlan Membership
Vlan Id[1 - 4094] ... (100)
1. Egress Tagged Ports > (1, 2)
2. Egress Untagged Ports > (–)
>
Please select item <1 to 2>
A - Add New VLAN ; F - Forward ; D - Delete
ESC-prev.menu; !-main menu; &-exit 1 M/ 1 C
Figure 5-12. Configuring Network Ports as VLAN 100 Members
Enabling the Ring Functionality
When the preliminary configuration is completed, enable the ring functionality.
³ To enable the ring functionality:
• From the Protection menu (Configuration > System > Protection), set the
Ring Administrative Status to Up.
IPmux-24 resets itself automatically.
The ring becomes operational, reversing the Ethernet traffic flow
direction, if one of the ring segments fails.