Specifications

Chapter 5 Configuring IPmux-24 for Typical Applications Installation and Operation Manual
5-4 Typical Pseudowire Application IPmux-24 Ver. 1.5
 Set IP address of the management station to 192.168.10.100.
 Set IP mask of the management station to 255.255.255.0.
3. Save the changes.
Configuration>System>Management>Manager List
Manager ID (1)
1. IP Address ... (192.168.10.100)
2. IP mask ... (255.255.255.0)
3. Trap Mask ... (Disable)
>
ESC-prev.menu; !-main menu; &-exit 1 Mngr/s
Figure 5-4. Adding a Network Manager
Configuring E1 Parameters at the Physical Layer
³ To configure E1 parameters at the physical layer:
1. Display the TDM (E1) menu (Configuration > Physical layer > TDM (E1)), and
configure the following parameters:
 IPmux-24 (A) and IPmux-24 (B) transmit clock source – Adaptive
 Line type – Framed G.704 CRC.
2. Save the changes.
Configuration>Physical layer>TDM (E1)
Channel ID (1)
Restoration time >(CCITT)
Signaling mode (CAS Disabled)
1. Administrative status (Up)
2. Transmit clock source >(Adaptive)
3. Source clock quality >(Other/unknown)
4. Trail Mode (Termination)
5. Line type >(Framed G.704)
6. Line interface (LTU)
7. Idle code[0 - ff] ... (7E)
8. Send upon fail (OOS Code)
9. OOS Code[0 - ff] ... (FF)
10.Ethernet network type >(WAN)
>
Please select item <1 to 10>
ESC-prev.menu; !-main menu; &-exit 1 Mngr/s
Figure 5-5. Configuring E1 at the Physical Level