Specifications

Installation and Operation Manual Chapter 4 Configuration
IPmux-24 Ver. 1.5 Additional Tasks 4-51
Configuration>System>Date/time
1. Set time <HH:MM:SS> ... (09:12:06)
2. Set date <YYYY-MM-DD> ... (2006-08-30)
>
Please select item <1 to 2>
ESC-prev.menu; !-main menu; &-exit 1 Mngr/s
Figure 4-41. Date/Time Menu
Displaying the IPmux-24 Status
The IPmux-24 software allows displaying information on the physical layer and
bundle connections. This section describes only status information of the IPmux-
24 device. For description of IPmux-24 alarms, refer to
Chapter 6 .
The status information is available via the Status menu.
Displaying the Physical Layer Information
At the physical level, you can view the Ethernet and SFP status.
Displaying the Ethernet Physical Layer Information
³ To display the Ethernet physical layer information:
• From the ETH Physical Layer screen (Monitoring > Status > Physical ports >
ETH physical layer), type F to toggle between the available Ethernet
interfaces.
Monitoring>Status>ETH Physical layer
Channel > (Network-Eth1)
Mode > (Full Duplex)
Rate(Mbps) > (100)
Status > (Connected)
>
F - forward
ESC-prev.menu; !-main menu; &-exit 1 Mngr/s
Figure 4-42. ETH Physical Layer Screen