Specifications

Chapter 4 Configuration Installation and Operation Manual
4-44 Configuring IPmux-24 for Operation IPmux-24 Ver. 1.5
³ To configure the VLAN membership:
1. From the Bridge menu, select VLAN Membership.
The VLAN Membership menu is displayed (see
Figure 4-34 ).
2. From VLAN Membership menu, type a and add a new VLAN, and enter the
new VLAN number or type f to select an existing VLAN, to which you intend to
assign the IPmux-24 port.
3. When the number of the required VLAN is displayed at the top of the menu,
do the following:
 Select Egress Tagged Ports to assign network and/or user ports to be the
tagged members of the current VLAN. These ports add the current VLAN
tag to all frames at egress.
 Select Egress Untagged Ports to assign network and/or user ports to be
the untagged members of the current VLAN. These ports strip the current
VLAN tag from all frames at egress.
Each port can be an untagged member in only one VLAN.
³ To assign an IPmux-24 port to a VLAN:
1. From the Egress Tagged Ports or Egress Untagged Ports menu, type a to add
a port.
The display changes, entering the Add mode (see
Figure 4-34 ).
2. When in Add mode, perform the following:
1. Select the IPmux-24 port range, displayed as [1 – 3], and enter the
desired port number.
2. Save the change.
3. Type a to add another port, and enter its number.
4. Save the change.
5. Press <Esc> to return to the VLAN Membership menu.
6. Save the changes.
³ To delete IPmux-24 ports assigned to VLAN:
1. From the Egress Tagged Ports or Egress Untagged Ports menu, select Delete
Range and specify network or user ports that you intend to disconnect from
the current VLAN and save the changes
The ports which will be disconnected are selected one after another or as a
group in the x-y format in the ascending order.
For example, if you want to disconnect ports 1, 2 and 3 from the VLAN, you
can do it in the following succession: Delete Range 1, Delete Range 2, Delete
Range 3, Save.
Alternatively, you can specify the port range and do it in just two steps as
follows: Delete Range 1-3, Save.
Note