Specifications

Chapter 4 Configuration Installation and Operation Manual
4-40 Configuring IPmux-24 for Operation IPmux-24 Ver. 1.5
Configuration>Bridge
1. VLAN Mode (Unaware)
2. Forwarding Mode (Transparent)
3. Aging Time[300 - 4080] ...(300)
4. Static MAC Table []>
5. Erase MAC Table
6. Bridge Port >
7. VLAN Membership >
ESC-prev.menu; !-main menu; &-exit 1 Mngr/s
Figure 4-28. Bridge Menu
Configuring MAC Table
You can add static MAC addresses to the IPmux-24 MAC table. When the bridge
operates in the VLAN-aware mode, it is possible to assign VLAN ID to a MAC address.
³ To add a static MAC addresses:
1. From the Bridge menu, select Static MAC Table.
The Static MAC Table appears (see
Figure 4-29 ).
2. From the Static MAC Table, type A to add a static MAC address.
The Static MAC Table display changes, entering the Add mode
(see
Figure 4-31 ).
3. When in Add mode, perform the following:
 Select MAC Address, and enter a new MAC address.
 Select Received Bridge Port, and choose an IPmux-24 interface this MAC
address will be attached to.
 If the bridge operates in the VLAN-aware mode, specify VLAN ID with
which frames from the current MAC address are expected to arrive.
 Save the changes.
 Press <Esc> to return to the Static MAC Table.
³ To remove a static address from the table:
• From the Static MAC Table (
Figure 4-29 ), select a MAC address that you want
to remove and type R.
The static MAC address is deleted from the table.
³ To delete static addresses from the MAC table:
1. From the Static MAC Table (
Figure 4-29 ), type C to delete all static MAC
addresses.
IPmux-24 displays the following message: Are you sure??? (Y/N)
2. Type Y to confirm deletion of all static MAC addresses from the table.