Specifications

Installation and Operation Manual Chapter 4 Configuration
IPmux-24 Ver. 1.5 Configuring IPmux-24 for Operation 4-35
Table 4-6. Connection Parameters (TDMoIP CE Connection, MPLS/ETH PSN)
Parameter Function Values
Destination IP Address See Table 4-5
Outbound Label
Tagging
Controls the use of an interworking
MPLS label for the transmit (outbound)
direction of the bundle. Network
termination units, such as IPmux-24,
ignore the outbound label.
Enable – Outbound tagging is enabled.
Disable – Outbound tagging is disabled.
Outbound Tunnel Label Specifies the outbound MPLS label used
for the bundle.
This parameter is displayed only when
Outbound Label Tagging is enabled.
16–1048575. 0 means that no label has
been defined.
Outbound EXP Bits Specifies the value of the outbound EXP
bits in the packet header used for the
bundle.
This parameter is displayed only when
Outbound Label Tagging is enabled.
0–7
Connection Status See Table 4-5
Destination Bundle See Table 4-5
Next Hop Type Type of the next hop device IP – The next hop device is an IP router
MAC – The next hop device is an MPLS LER
Next Hop See Table 4-5
TDM Bytes in Frame
(x48 bytes)
See Table 4-5
Payload Format See Table 4-5
Far End Type See Table 4-5
OAM Connectivity See Table 4-5
Jitter Buffer See Table 4-5
Sensitive See Table 4-5
OOS Mode See Table 4-5
VLAN Tagging See Table 4-5
VLAN ID See Table 4-5
Table 4-7. Connection Parameters (CESoPSN Connection, UDP/IP PSN)
Parameter Function Values
Destination IP Address See Table 4-5
Next Hop See Table 4-5
IP TOS See Table 4-5