Specifications

Chapter 4 Configuration Installation and Operation Manual
4-34 Configuring IPmux-24 for Operation IPmux-24 Ver. 1.5
Parameter Function Values
OAM connectivity Controls the use of the OAM connectivity
protocol for this bundle.
The OAM connectivity protocol enables
detecting loss of communication with
the destination of TDMoIP traffic and
taking steps that prevent the resulting
flooding. The protocol also enables
checking that the destination uses a
compatible configuration.
The selection must be compatible with
the equipment at the far end of the
connection.
ENABLE – The use of the OAM
connectivity protocol is enabled. This is
the recommended selection. Make sure to
select V2 for Payload Format.
DISABLE – The use of the OAM
connectivity protocol is disabled.
Jitter Buffer Specifies the value of the jitter buffer to
be used on this bundle.
You should use the shortest feasible
buffer, to minimize connection latency.
2.5–180 msec (framed)
0.5–180 msec (unframed)
Sensitive Specifies whether to optimize the clock
for accurateness or for constant delay
Data – Accurate clock is more important
than constant delay
Delay – Constant delay is more important
than accurate clock
OOS Mode Defines whether Out of Service (OOS)
signal is transmitted. The OOS signal is
sent toward the IP path when loss of
signal, loss of frame, or AIS is detected
at the TDM line.
Tx OOS – OOS transmission is enabled
OOS suppression – OOS transmission is
disabled
VLAN Tagging Controls the use of VLAN tagging for the
traffic generated by this bundle
Enable – VLAN tagging is enabled.
Disable – VLAN tagging is disabled.
VLAN ID When VLAN tagging is enabled, specifies
the VLAN ID number used by the bundle
traffic sent through this port.
When VLAN tagging is disabled, this
parameter is not displayed
1 to 4094
0 means that no VLAN ID has been
specified.
VLAN Priority When VLAN tagging is enabled, specifies
the priority assigned to the bundle
traffic using the selected VLAN.
When VLAN tagging is disabled, this
parameter is not displayed
0–7