Specifications

Installation and Operation Manual Chapter 4 Configuration
IPmux-24 Ver. 1.5 Configuring IPmux-24 for Operation 4-33
Parameter Function Values
Destination Bundle Bundle number in the destination device.
IPmux-24 automatically adds the
following values to the destination and
source bundle number:
• +15, when the PSN type is set to
MPLS
• +0xc000 when the CESoPSN and
SAToP PWs operate over UDP/IP PSN
• +1 when the TDMoIP is set to the V1
payload format.
1–8063
TDM Bytes in Frame
(x48 bytes)
UDP payload length, enabling reduction
of Ethernet throughput
1–30
Payload Format Selects the TDMoIP payload format.
The selection must be compatible with
the equipment at the far end of the
connection. The payload format is valid
for TDMoIP CE PWs and UDP/IP PSNs.
V1 – Old TDMoIP format, defined as
experimental in the relevant IETF drafts.
Not recommended for use.
TDMoIP version V1 requires two UDP
sockets per bundle, whereas TDMoIP V2
requires a single UDP socket per bundle.
The larger number of UDP sockets per
bundle needed by TDMoIP V1 reduces the
maximum number of bundles to a given
destination supported by IPmux-24.
V2 – Current TDMoIP format. Requires one
UDP socket per bundle.
Far end type Specifies the type of framing used by
the equipment at the destination
endpoint. The selected value also
determines the encoding law used on
PCM voice channels.
Make sure to select the same value at
both end points. The selected value
must also match the Line Type
configured for the physical port of the
bundle local endpoint.
E1 – E1 stream with G.704 framing. The
PCM signals are processed assuming that
they are encoded in accordance with the
A-law. You can use this selection when
the port Line Type is a FRAMED version.
T1 ESF – T1 stream with ESF framing. The
PCM signals are processed assuming that
they are encoded in accordance with the
μ-law.
T1 (SF) – T1 stream with SF (D4) framing.
The PCM signals are processed assuming
that they are encoded in accordance with
the μ-law.
Unframed/serial – unframed data stream,
transparently transferred. You can use
this selection when the port Line Type is
unframed.