Specifications

Chapter 4 Configuration Installation and Operation Manual
4-32 Configuring IPmux-24 for Operation IPmux-24 Ver. 1.5
Table 4-5. Connection Parameters (TDMoIP CE Connection, UDP/IP PSN)
Parameter Function Values
Destination IP Address IP address of the destination device Vald IP address
Next Hop Use the next hop parameter when the
destination IP address is not in the
device subnet. In such cases the
Ethernet frame is sent to the next hop
IP. If it is not configured, the default
gateway is used.
Vald IP address
IP TOS Specifies the Layer 3 priority assigned to
the traffic generated by this bundle.
For IP networks, this priority is indicated
by the IP type-of-service parameter for
this bundle. The specified value is
inserted in the IP TOS field of the bundle
IP packets.
When supported by an IP network, the
type-of-service parameter is interpreted,
in accordance with RFC 791 or RFC 2474,
as a set of qualitative parameters for the
precedence, delay, throughput and
delivery reliability to be provided to the
IP traffic generated by this bundle.
These qualitative parameters may be
used by each network that transfers the
bundle IP traffic to select specific values
for the actual service parameters of the
network, to achieve the desired quality
of service
You can also specify a Layer 2 priority by
means of the VLAN Priority field,
provided VLAN Tagging for this bundle is
Enable.
0–255
In accordance with RFC 2474, it is
recommended to use only values which
are multiples of 4.
Connection Status Administrative status of the connection Enable – Connection is active
Disable –The connective is not active. You
can still configure and save the desired
parameters, to prepare the bundle for
activation when needed.