Specifications

Chapter 4 Configuration Installation and Operation Manual
4-26 Configuring IPmux-24 for Operation IPmux-24 Ver. 1.5
Configuration>Physical layer>TDM (T1)
Channel ID (1)
1. Administrative status (Up)
2. Transmit clock source >(Adaptive)
3. Source clock quality >(Other/unknown)
4. Rx Sensitivity (Short haul)
5. Trail Mode (Termination)
6. Line type >(ESF)
7. Line code >(B8ZS)
8. Line interface >(DSU)
9. Line length (feet) >(0-133)
10. Restoration time >(TR-621 (10 seconds))
11. Idle Code[0 - ff] ... (7E)
12. Send upon fail (OOS Code)
13. OOS code[0 - ff] ... (FF)
14. Signaling mode (Robbed Bit)
15. OOS signaling > (Space)
16.Mark signaling code[0 - f] ... (D)
17.Space signaling code[0 - f] ... (1)
18.Ethernet network type > (Wan)
>
Please select item <1 to 18>
ESC-prev.menu; !-main menu; &-exit 1 Mngr/s
Figure 4-22. TDM (T1) Menu
Configuring Ethernet Interfaces
IPmux-24 includes one network and up to two user Ethernet ports.
³ To configure Ethernet interface:
1. From the Physical Layer menu (
Figure 4-18 ), select ETH.
The ETH menu appears (see
Figure 4-23 ).
2. From the ETH menu, type F to select the Ethernet interface that you intend
to configure (Network ETH1, Network/User ETH2 or User ETH3).
3. When the required Ethernet interface is displayed, configure the following:
 Administrative status:
 Up (Current Ethernet interface is enabled)
 Down (Current Ethernet interface is disabled)
 Auto negotiation:
 Enable (Autonegotiation is enabled)
 Disable (Autonegotiation is disabled)