Specifications

IPmux-1/1E Installation and Operation Manual Appendix E Configuration Menus
Ethernet Configuration/Status (User Port) E-49
Erase MAC Table
The MAC table is erased automatically every time you change the general
operating mode of the switch, or you remove a VLAN membership.

To erase the MAC Table: x
1. On the Switch Configuration menu, select 3.
A confirmation line appears.
Traffic will be disrupted. Are you sure?
Figure E-50. Erase MAC Table Confirmation
2. Answer Y to erase the table.
Erasing the MAC table takes about 2 seconds, during which time all traffic
through the switch is halted.
VLAN Configuration
When working in Basic/Rate modes, a warning prints: VLAN tagging must be
enabled for VLAN table to take effect.
VLAN CONFIGURATION
VLAN ID 1
Network No
User1 No
Network VLANs:
User1 VLANs:
Internal VLANS:
ESC. Exit
Select item from the menu:
Figure E-51. VLAN Configuration
Table E-33. VLAN Configuration – User Tagged, User Untagged, Rate+User Untagged Modes
Parameter Values Remarks
VLAN ID 1 to 4094 Selects the VLAN to edit. Creates a VLAN entry if the
VLAN does not exist.
Network
Yes
No
Network port is a member of VLAN
Network port is not a member
User1
Yes
No
User1 port is a member of VLAN
User1 port is not a member of VLAN
‘N’ pages between VLANs, ‘D’ deletes the current VLAN.
Main Menu
↓
2. Configuration
↓
4. Switch
Configuration
↓
4. VLAN
Configuration
Note
Note
Main Menu
↓
2. Configuration
↓
4. Switch
Configuration
↓
3. Erase MAC
Table