Specifications
Appendix E Configuration Menus IPmux-1/1E Installation and Operation Manual
E-48 Ethernet Configuration/Status (User Port)
LAN Configuration
LAN CONFIGURATION
1. Channel Network
2. Channel Status Enable
3. Auto Negotiation Enable
4. Max Capability advertised 100BaseT Full Duplex
5. Default type 100BaseT Full Duplex
6. VLAN Tagging Yes/No
7. Default VLAN
8. Rate limit (kbps) (0–Disable) 100
ESC. Exit N. Next
Select item from the menu.
Figure E-49. LAN Configuration – Two Ethernet Ports
Table E-32. LAN Configuration – Two Ethernet Ports
Parameter Values Remarks
Channel Network, User Selects port to be configured
Channel Status Enable, Disable When disabled, Ethernet LOS Events will not be sent to
the Logfile
Auto Negotiation Enable, Disable Enables the auto-negotiation mode (RFC 2239)
Max Capability
Advertised
10BaseT Full-duplex,
10BaseT Half-duplex,
100BaseT Full-duplex,
100BaseT Half-duplex
Default: 100baseT Full-duplex
Note: This parameter is valid only when the Auto
Negotiation mode is enabled (RFC 2239).
Default type 10BaseT Full-duplex,
10BaseT Half-duplex,
100BaseT Full-duplex,
100BaseT Half-duplex
Default: 100baseT Full-duplex
Note: This parameter is valid only when the Auto
Negotiation mode is enabled (RFC 2239).
VLAN Tagging Yes
No
Switch works in tag or tag+rate mode
No (default) – switch works in basic or rate mode
Default: No
Default VLAN VLAN associated with untagged frames arriving at the port.
This item is displayed only in user tagged, user untagged,
rate+user untagged modes.
Rate limit
<0-Disable>
50k to 5 Mb: in steps of 50k
5 Mb to 100 Mb:
in steps of 1 Mb
Only relevant to Network port.
Default: 100 Mb
• When VLAN Tagging is enabled at the Network, the bundle and all managers
must use VLAN tagging with VLAN ID (VLAN ID not equal to 0).
• The Rate Limiter restricts the user port bandwidth:
In steps of 50K, up to 5M
From 5M–100M in steps of 1M.
A more detailed explanation is found in Chapter 1
.
Main Menu
↓
2. Configuration
↓
4. Switch
Configuration
↓
1. LAN
Configuration
Notes