Specifications

Appendix E Configuration Menus IPmux-1/1E Installation and Operation Manual
E-38 DS0 Bundle Configuration
Table E-25. LAN Configuration Parameters
Parameter Possible Values Remarks
Auto Negotiation
Enable, Disable
Auto Negotiation mode is according to RFC 2239
Default: Enable
Maximum Capabilities
Advertised
Maximum Capabilities of the port for the Auto
Negotiation process (can be lower then the actual
capabilities)
Default: 100baseT Full-duplex
Default Type
10BaseT Half-duplex,
10BaseT Full-duplex,
100BaseT Half-duplex,
100BaseT Full-duplex
Default: 100baseT Full-duplex
Note: This parameter is valid only when the Auto
Negotiation mode is disabled (RFC 2239).
If Auto Negotiation is set to Enable and you experience some incompatibility in the
Auto Negotiation process, set Auto Negotiation to Disable and set Default type to
the desired mode.
When the physical port is fiber, the operation mode is:
Auto Negotiation Off//full duplex/100 Mbps. This is the only possible setting.
E.10 DS0 Bundle Configuration
This configuration selects the timeslots to be transferred end-to-end for E1/T1
when the operation mode is Fractional or Fractional with CAS. One bundle of
timeslots can be configured in the IPmux-1 TDMoIP® link.
DS0 BUNDLE CONFIGURATION
1. Timeslot number 1-1
2. Timeslot Current Status SET
3. Echo Cancellation Status SET
ESC. Exit
ACTIVE TIMESLOTS IN THIS BUNDLE: 1
FREE TIMESLOTS: 2,3,4,5,6,7,8,9,10,11,12,13,14,15,17,
18,19,20,21,22,23,24,25,26,27,28,29,30,31
ACTIVE ECHO CANCELLATION TIMESLOTS:
Select item from the menu.
Use <Esc> key or keys <1> to <3>
Figure E-40. DS0 Bundle Configuration Menu
Main Menu
↓
2. Configuration
↓
5. DS0 Bundle
Configuration
Note