Specifications

Appendix E Configuration Menus IPmux-1/1E Installation and Operation Manual
E-36 Connection Configuration: CESoIP Mode
Bundle Connection Configuration: CESoIP Mode
BUNDLE CONNECTION CONFIGURATION
1. Bundle ID 1
2. IP TOS 1
3. Packet Delay (mSecs)
4. Connection Status Disable
5. Destination IP Address 0.0.0.0
6. Next Hop 0.0.0.0
7. Source UDP
8. Destination UDP
9. Jitter Buffer 300
A. VLAN Tagging Yes
B. VLAN ID 1
C. VLAN Priority 00
ESC. Exit
Calculated bundle throughput [BPS]: 3978080
Select item from the menu.
Figure E-38. Bundle Connection Configuration: CESoIP Mode
Parameters must be configured for each connection. To configure all parameters,
first select the bundle ID and then proceed with the parameter configuration.
• First define the bundle.
• When changing the Destination IP Address, Next Hop, or Destination Bundle,
the Connection Status must be set to Disable. After you save the changes,
Connection Status can be reset to Enable.
Table E-24. Bundle Connection Parameters: CESoIP Mode
Parameter Possible Values Remarks
Bundle ID
1
IPmux-1 has a single bundle, with the number set
at 1
IP ToS 0 to 255 Type of Service – sets the IP ToS field in the IP frames
transmitted by the device.
ToS configuration configures the WHOLE byte, since
different vendors may use different bits to tag packets for
traffic prioritization
ToS assignment applies to all TDM packets leaving IPmux-1
Default: 0
Packet Delay 1 to 63 msec The maximum value depends on the number of time slots.
Connection Status
Enable
Disable
Connection enabled
Frames will not be sent from this connection
Destination IP Address 0.0.0.0 to
255.255.255.255
IP address of the destination device
VLAN ID and
VLAN Priority are
configurable only if
VLAN Tagging is
set to Yes.
Main Menu
↓
2. Configuration
↓
3. Connection
Configuration
↓
2. Bundle
Connection
Configuration
Note