Specifications

IPmux-1/1E Installation and Operation Manual Appendix E Configuration Menus
Connection Configuration: CESoIP Mode E-35
Table E-23. Activation Criterion Parameters
Parameter Possible Values Remarks
Pattern ID 1 to 4 An OR operation will be performed on the pattern
defined here
At least one pattern must be defined. For each
defined pattern at least one bit must be configured
to either 0 or 1.
Tx A
0, 1
N/C
Defines CAS A bit
Ignored
Tx B
0, 1
N/C
Defines CAS B bit
Ignored
Tx C
0, 1
N/C
Defines CAS C bit
Ignored
Tx D
0, 1
N/C
Defines CAS D bit
Ignored
E.8 Connection Configuration: CESoIP Mode

To configure the Connection:
1. Select 1 to enter the Connection Mode. Use the <Space bar> to select
CESoIP and then press <Enter>.
For CESoIP: The E1/T1 Signaling Mode must be configured as CAS Disable or the
Line Type configured as Unframed.
To change the Connection Mode from Dynamic CAS to CESoIP:
Change the Connection Mode to Static.
Update the E1/T1 Signaling Mode or Line Type.
Change the Connection Mode to CESoIP
2. Enter the Bundle Connection Configuration data (described later in this
section).
The Bundle Connection Configuration menu for CESoIP Mode differs from the
menus used for Static Mode and for Dynamic CAS Mode.
3. Enter the Activation Criterion data (described later in this section).
CONNECTION CONFIGURATION
1. Connection Mode CESoIP
2. Bundle Connection Configuration >
ESC. Exit
Figure E-37. Connection Configuration
Main Menu
↓
2. Configuration
↓
3. Bundle
Connection
Configuration
Note
Note