Specifications

Appendix E Configuration Menus IPmux-1/1E Installation and Operation Manual
E-34 Connection Configuration: Dynamic CAS Mode
Table E-22. Bundle Connection Parameters: Dynamic CAS Mode (Cont.)
Parameter Possible Values Remarks
Connection Status
Enable
Disable
Connection enabled
Frames will not be sent from this connection
Destination IP Address 0.0.0.0 to
255.255.255.255
IP address of the destination device
Next Hop 0.0.0.0 to
255.255.255.255
Use the next hop parameter when the Destination IP
address is not in the device subnet. In such cases the
Ethernet frame is sent to the next hop IP. If it is not
configured, the default gateway is used.
Default: 0.0.0.0 (not configured)
Note: The next hop IP must be in the device subnet.
Destination Bundle E1: 1 to 496
T1: 1 to 384
Bundle number in the destination device
Jitter Buffer 3 to 300 milliseconds
(ms)
Desired depth of the jitter buffer (PDVT buffer)
Default: 300 (10 x µs), i.e. 3 msec
OAM Connectivity
Enable
Disable
The device starts transmitting at full rate after it
detects an active, properly configured, Ipmux on the
other side of the line.
Default: Disable
VLAN Tagging
Yes
No
For an explanation of VLAN tagging, see Chapter 1.
VLAN ID 0 to 4095
Default: 1
VLAN Priority 0 to 7
Default: 7
Activation Criterion
Activation Criterion
1. Pattern ID 1
2. Tx A 1
3. Tx B N/C
4. Tx C N/C
5. Tx D N/C
ESC. Exit D. Delete N. Next
Figure E-36. Activation Criterion Menu
Main Menu
↓
2. Configuration
↓
3. Connection
Configuration
↓
3.
Activation
Criterion