Specifications

Appendix E Configuration Menus IPmux-1/1E Installation and Operation Manual
E-30 Connection Configuration: Static Mode
Table E-20. Bundle Connection Parameters: Static Mode (Cont.)
Parameter Possible Values Remarks
Connection Status
Enable
Disable
Connection enabled
Frames will not be sent from this connection
Destination IP Address 0.0.0.0 to
255.255.255.255
IP address of the destination device
Next Hop
0.0.0.0 to
255.255.255.255
Use the next hop parameter when the Destination IP
address is not in the device subnet. In such cases the
Ethernet frame is sent to the next hop IP. If it is not
configured, the default gateway is used.
Default: 0.0.0.0 (not configured)
Note: The next hop IP must be in the device subnet.
Destination Bundle E1: 1 to 496
T1: 1 to 384
Bundle number in the destination device
Jitter Buffer 3 to 300
milliseconds
(ms)
Desired depth of the jitter buffer (PDVT buffer).
Default: 300 (10 x µs), i.e. 3 msec
OAM Connectivity
Enable
Disable
The device starts transmitting at full rate after it detects an
active, properly configured, Ipmux on the other side of the
line.
If the Redundancy Type in the Protection Switching menu is
set to 1:1, OAM Connectivity must be set to Enable.
Default: Disable
Redundancy Function
None,
Secondary,
Primary
Read-only (the value is set according to the selection made
in the Protection Switching Configuration menu, see
Figure E-33).
VLAN Tagging
Yes
No
For an explanation of VLAN tagging, see Chapter 1.
VLAN ID 0 to 4095
Default: 1
VLAN Priority 0 to 7
Default: 7