Specifications

Appendix E Configuration Menus IPmux-1/1E Installation and Operation Manual
E-28 Connection Configuration: Static Mode
E.6 Connection Configuration: Static Mode
The Connection Configuration menu changes according to the Connection Mode
selection (item 1). This section describes Static mode. For Dynamic CAS mode and
CESoIP mode, see separate descriptions later in this manual.

To configure the connection:
1. Select 1 to enter the Connection Mode. Use the <Space bar> to select Static
and then press <Enter>.
2. Enter the Bundle Connection Configuration data (described later in this
section).
3. Select 3, enter the Secondary IP Address, and press <Enter>.
4. Select 4, enter the Secondary IP Mask and press <Enter>.
5. Enter the Protection Switching Configuration data (described later in this
section).
CONNECTION CONFIGURATION
1. Connection Mode Static
2. Bundle Connection Configuration >
3. Secondary IP Address Empty!
4. Secondary IP Mask Empty!
5. Protection Switching Configuration >
ESC. Exit
Figure E-31. Connection Configuration
Table E-19. Connection Configuration
Parameter Possible Values Remarks
Connection
Mode
Static, Dynamic
CAS, CESoIIP
When using redundancy, the connection mode must be set to
Static.
Secondary IP
Address
Secondary IP
Mask
0.0.0.0 to
255.255.255.255
Configure a virtual IP address to be used as a secondary bundle IP
source address
Main Menu
↓
2. Configuration
↓
3. Connection
Configuration
Note