Specifications

Appendix E Configuration Menus IPmux-1/1E Installation and Operation Manual
E-12 General Configuration
Table E-5. Alarm Traps Mask Parameters
Parameter Possible Values Remarks
Alarm ID
1, 2, 6, 8, 21, 26
IPmux-1/1E alarm
Trap Status
Active
Masked
Generates an alarm
Does not send an alarm
Default for all traps: Masked
Table E-6. IPmux-1/1E Alarms
Alarm ID Alarm Description Trap Sent to NMS
1 Loss of Signal (LOS Physical Layer) Alarm LOS
1.3.6.1.4.1.164.6.1.3.0.7
2 Loss of Frame (LOF Physical Layer) Alarm LOF
1.3.6.1.4.1.164.6.1.3.0.8
6 Alarm Indication Signal Received (AIS
Line Physical Layer)
Alarm AIS
1.3.6.1.4.1.164.6.1.3.0.10
8 Remote Defect Indication Received (RDI
Line Physical Layer)
Alarm RDI
1.3.6.1.4.1.164.6.1.3.0.11
21 Far End Block Error (FEBE Line Layer) Alarm FEBE
1.3.6.1.4.1.164.6.1.3.0.12
26 Connectivity Status Conn Status Trap
1.3.6.1.4.1.164.6.1.3.0. 15
The other alarms are not used.
Telnet Access
It is possible to manage the IPmux-1/1E inband via remote ASCII Terminal using
the Telnet IP protocol.

To configure Telnet Access:
• Select:
 Enable –Telnet is enabled
 Disable – Telnet is disabled
 Managers – Telnet is enabled only when the Managers List contains the IP
and VLAN of the computer that opens the Telnet session (see Appendix B).
Note
Main Menu
↓
2. Configuration
↓
1. General
Configuration
↓
2. Management
Configuration
↓
4
.
T
e
ln
et
A
ccess