Specifications

Chapter 4 Troubleshooting and Diagnostics IPmux-1/1E Installation and Operation Manual
4-18 Performance Monitoring and Troubleshooting Statistics
Table 4-6 Bundle Connection Status Parameters (Cont.)
Parameter Description
Connectivity
Status
Disabled: No activity in the channel. The channel is disabled.
OK
: Both the remote and the local IPmux receive Ethernet frames, (however, there may be
problems such as sequence errors, underflows, overflows, as explained below).
Local Fail
: The loacal IPmux does not receive Ethernet frames.
Remote Fail
: The remote IPmux does not receive Ethernet frames.
Unavailable:
The remote Ipmux does not reply to OAM messages (only applicable when
OAM is enabled).
Validation Fail
: The remote Ipmux replies, but there is a configuration error (only applicable
when OAM is enabled).
Standby
: Redundant bundle is OK and wiaitng for redundancy switching (only applicable
when Redundancy is enabled).
TDM Fail
: There is LOS/LOF at the TDM side (only applicable when Redundancy is
enabled).
Note: While under Disable or Local Failure or Remote Failure status, the statistic counters will
be inactive.
Destination
IP Address
The IP address of the opposite IPmux, to which the bundle is destined.
Next Hop
MAC
Address
Layer 2 Applications: the MAC address displayed is the MAC address of the remote IPmux.
Layer 3 Applications: the MAC address displayed is the MAC address of the connected
router.
Connectivity
Status
Disabled: No activity in the channel. The channel is disabled.
OK
: Both the remote and the local IPmux receive Ethernet frames, (however, there may be
problems such as sequence errors, underflows, overflows, as explained below).
Local Fail
: The loacal IPmux does not receive Ethernet frames.
Remote Fail
: The remote IPmux does not receive Ethernet frames.
Unavailable:
The remote Ipmux does not reply to OAM messages (only applicable when
OAM is enabled).
Validation Fail
: The remote Ipmux replies, but there is a configuration error (only applicable
when OAM is enabled).
Standby
: Redundant bundle is OK and wiaitng for redundancy switching (only applicable
when Redundancy is enabled).
TDM Fail
: There is LOS/LOF at the TDM side (only applicable when Redundancy is
enabled).
Note: While under Disable or Local Failure or Remote Failure status, the statistic counters will
be inactive.