System information

RADview-SC/TDMoIP IPmux-11 Monitoring Object Status 7-1
Chapter 7
Fault Management
This chapter describes how to manage IPmux-11 alarms and how to run a
loopback test, and contains the following sections:
• Monitoring Object Status
 Masking Traps
 Viewing Active Alarms
 Viewing the History Log
 Clearing the History Log
 Viewing Self Test Results
• Performing Loopback Tests
7.1 Monitoring Object Status
This section discusses monitoring the status of network objects including managing
alarms.
Masking Traps
The Masking Traps command enables you to select which SNMP traps should be
masked (disabled). You can mask a trap in order to prevent a known problem from
causing repeated alerts at the network monitoring station and to enable focusing
on new problems that may arise. All traps can be selected or deselected for
masking as a group, or they can be selected individually.

To manually select traps for masking:
1. Select Options > Masking Traps…
The Masking Traps dialog box appears (
Figure 7-1).
2. Select which traps to mask, and then click <Set>.