System information

Chapter 4 Configuring Typical Applications User's Manual
4-12 Creating Circuits RADview-SC/TDMoIP IPmux-11
5. Click on the EP Param tab (Figure 4-11) and configure the following
parameters:
 Jitter Buffer = 500.
Figure 4-11. Manual Circuit Dialog Box – EP Param Tab
Saving the Circuit Parameters

To save the circuit parameters:
1. In the Manual Circuit Dialog Box, click <Set>.
A message appears asking you if you want to create another circuit.
2. Click <No>.
The circuit is created and appears on the Mesh Services Map.