System information

User's Manual Chapter 3 Configuration Management
RADview-SC/TDMoIP IPmux-11 Additional Tasks 3-25
Resetting IPmux-11 to the Default Configuration
The Default Configuration command enables you to reset the Agent’s
configuration back to the factory defaults. Use this command when you wish to
reconfigure all of the parameters from a clean starting point. This is useful when
IPmux-11's current configuration is completely unsatisfactory, such as when
moving a device to another site, or if the configuration database has become
corrupted or the device's software has been upgraded.

To set the selected IPmux-11 to the default configuration:
1. Select Configuration > System Commands > Default Configuration.
A confirmation message appears (
Figure 3-20).
Figure 3-20. Default Configuration Dialog Box
2. Click <OK> to confirm reset of the default configuration.
The default configuration replaces the current configuration.
Polling the Agent
RADview periodically and automatically reads (polls) IPmux-11 variables. You can
force RADview to immediately poll the Agent and update the display by polling
IPmux-11 manually. The Poll Agent command is useful if you configure the device
NOT to perform periodic polling of the Agent.

To poll the agent:
• Select Configuration > System Commands > Poll Agent.
RADview polls IPmux-11 and updates any displayed information.
Resetting IPmux-11
The Reset command enables you to reset the Agent’s hardware to re-initialize the
main board CPU of the IPmux-11 unit. Use this command to reset IPmux-11 in
the unlikely event that the device is unresponsive (has locked up) or is behaving
erratically.

To reset IPmux-11:
1. Select Configuration > System Commands > Reset.
A confirmation message appears (
Figure 3-21).
2. Click <OK> to confirm.
The Agent’s hardware resets; the IPmux-11 unit is re-initialized and its
active software is decompressed and loaded into the RAM.