System information

Chapter 3 Configuration Management User's Manual
3-24 Additional Tasks RADview-SC/TDMoIP IPmux-11
3.3 Additional Tasks
Displaying Ethernet Interface Information
The Ethernet Interface Information command enables you to display the various
parameters of the Ethernet port. You can use this information as a troubleshooting
aid, to ensure that the Ethernet cable is working properly and that the connection
is at the appropriate speed at half/full duplex.

To display information about the Ethernet interface:
1. Click the Ethernet port.
2. Select Configuration > Interface Info...
The Interface Information table appears.
Figure 3-19. Interface Information – Network/User Port
Table 3-12. Interface Information Table Parameters
Parameter Possible Values / Remarks
Port
NETWORK, USER
Type
ETH
MAC Address MAC Address
Mode Transmission mode: Full Duplex, Half Duplex
Rate (Mbps) Transmission rate: 10, 100
Status Status of the link: Connected, Not Connected
Interface Type According to wavelength and laser mode
1300nmSM or 1300nm (single mode/multimode)
Note: Only for fiber optic Ethernet interface