System information

Chapter 3 Configuration Management User's Manual
3-22 Setting the Operational Parameters RADview-SC/TDMoIP IPmux-11
Table 3-11. Bundle Connection Table Parameters
Parameter Possible Values/Remarks
Slot No.
1
Channel No.
1
Bundle No.
1..31
Note: A maximum of 16 bundles are allowed
Bundle Name Bundle name of the selected channel. The Table displays one bundle name
per line.
Admin. Status
Connected
Disconnected - Frames will not be sent from this channel.
Oper Status
Connected, Disabled , Remote Fail, Local Fail, Unavailable, Validation Fail,
Standby, Sequence Error, Buffer Underflow, Buffer Overflow
Dest. Name Logical name or IP address of the destination IPmux
Next Hop IP address to which the Ethernet frame will be sent when the Dest. Name IP is
not in the device subnet
Dest. Bundle Bundle number in the destination IPmux device
1..496
Jitter Buffer (tens of μsec) Depth of the jitter buffer (per link, elastic buffer, whose size is configurable in
units of 10 micro seconds (μs).
E1: 0..37..3200
T1: 0..37..2400
ToS IP ToS (Type of Service) assigned to this channel
0
..255
Configures the IP ToS field in the IP frames transmitted by the device.
Configures the entire byte – not only the 3 ToS bits. ToS assignment applies to
all TDM packets leaving IPmux.
TDM Bytes in Frame UDP payload (one-eight) length enabling reduction of Ethernet throughput.
E1/T1:
48..1440 (steps of 48)
VLAN Tagging
No, Yes
VLAN ID VLAN ID
1
..4094
VLAN Priority VLAN priority
0
..7
OAM Connectivity
Disabled
Enabled
Bundle Thoughput Throughput in bps
PSN Type Bundle encapsulation
MPLS/ETH - Multi-Protocol Label Switching / Ethernet
UDP/IP
Connection Mode TDMoIP (CE) - Time Division Multiplexing over the Internet Protocol
(Circuit Emulation)