System information

Chapter 3 Configuration Management User's Manual
3-18 Setting the Operational Parameters RADview-SC/TDMoIP IPmux-11
Table 3-9. Ethernet Interface Parameters
Parameter Possible Values / Remarks
Port
User, Network
Type
ETH
Auto Negotiation Checked (enabled), Unchecked (disabled)
Note: Disabled for fiber optic Ethernet interface
Max Capability
Advertised
Defines the maximum capabilities of the interface.
Only applicable when autonegotiation is enabled.
10BASE-T half duplex mode, 10BASE-T full duplex mode,
100BASE-TX half duplex mode, 100BASE-TX full duplex mode
Note: Working in half duplex mode is not optimal and might cause communication
problems.
Disabled for fiber optic Ethernet interface.
Default Type
10BASE-T half duplex mode, 10BASE-T full duplex mode,
10BASE-TX half duplex mode, 10BASE-TX full duplex mode
Only applicable when autonegotiation is disabled
Rate Limit (Kbps)
Disable, 256, 512, 1000, 2000, 4000, 8000, 16000, 20000, 32000, 40000,
64000, 80000
Note:
• The Rate Limit parameter is read-only.
• 2000, 40000, and 80000 are only available for the Network Port.
• 32000 and 64000 are only available for the User Port.
VLAN Tagging VLAN Tagging
Unmodified, Tag, Double Tag, Untag
Note: Double Tag is not available for the Network Port.
Default VLAN Default VLAN
Default VLAN Priority
0..7
When Rate Limit is 32000: 2..7
When Rate Limit is 64000: 4..7
When Auto Negotiation is disabled and Max Capability Advertised is different
from the capabilities of the LAN, for example, when Max Capability is 100BaseT full
duplex, while the LAN is 10BaseT half duplex, the NMS will disconnect.
Assigning Timeslots to Bundles
Bundles are groups of timeslots. The Bundles Table displays the details of each
bundle in the upper section of the table, and a representation of each timeslot
with the bundle assigned to it in the lower section of the table. Each bundle can be
assigned to multiple timeslots, but each time slot can only have one bundle
assigned to it.
Note