System information

User's Manual Chapter 3 Configuration Management
RADview-SC/TDMoIP IPmux-11 Setting the Operational Parameters 3-17
Parameter Possible Values / Remarks
Mark Signaling
Code
Trunk conditioning signal value after alarm detection
E1, T1-ESF: 1..F
T1-SF(D4): 1..4
OOS Code Trunk conditioning data pattern to be sent upon a DS0 fail
Note: When Line Type is set to Unframed, OOS Code is grayed out and its value cannot
be changed.
AIS Transmit
Enable, Disable
Trail Mode Enables the end-to-end transfer of TDM OAM in framed mode, when theirTDMoIP
Payload Format is set to V2.
Termination - Trail mode is disabled
Extension - Trail mode is enabled
Configuring the Ethernet Ports
The Ethernet Interface Parameters command enables you to configure the various
parameters of the Ethernet port (the port’s software configuration).

To set configuration parameters for the Ethernet interface:
1. Click the User or Network Ethernet port.
2. Select Configuration > Parameters...
The Network Ethernet Interface Parameters dialog box appears
(
Figure 3-14).
The User Ethernet rate is the smaller value of User Rate Limit and
(100–TDMoIP traffic).
Figure 3-14. Ethernet Interface Parameters Dialog Box
Note