System information

Chapter 3 Configuration Management User's Manual
3-12 Setting the System Parameters RADview-SC/TDMoIP IPmux-11
Configuring Quality of Service (Rate Limitation)
The Rate Limitation command enables you to configure rate limits for IPmux-11,
in order to maintain Quality of Service (QoS) during times of high network traffic.
You can select Ingress Rate Boundaries to define the rate limiting ranges for the
ingress traffic. The actual data rate of the incoming traffic is selected from the rates
limited by the boundaries. These boundaries are applied to the regular and
flooded Rate Limits. You can also select regular or flooded Rate Limits, to be
applied to all frames.
To configure Quality of Service (Rate Limitation):
1. Select Configuration > QoS > Rate Limitation…
The Rate Limitation dialog box appears.
2. Configure the desired parameters and click Set.
Figure 3-10. Rate Limitation Dialog Box
Table 3-7. Rate Limitation Parameters
Parameter Possible Values / Remarks
Boundaries Defines the valid ranges of ingress rate
256 Kbps – 64 Mbps
5 Mbps – 80 Mbps
25 Mbps – 50 Mbps
Rate Limit The maximum rate permitted to transfer via this port (per Ethernet port:
Network/User1/User2)
For Network ports:
Disable, 256 Kbps, 512 Kbps, 1 Mbps, 2 Mbps, 3 Mbps, 3.5 Mbps,
4 Mbps, 4.5 Mbps, 5 Mbps, 8 Mbps, 10 Mbps, 16 Mbps, 20 Mbps,
25 Mbps, 40 Mbps, 50 Mbps, 80 Mbps
For User1/User2 ports, when Boundaries is set to 256 Kbps – 64 Mbps
:
Disable, 256 Kbps, 512 Kbps, 1 Mbps, 2 Mbps, 4 Mbps, 8 Mbps,
16 Mbps, 32 Mbps, 64 Mbps