System information

Chapter 3 Configuration Management User's Manual
3-10 Setting the System Parameters RADview-SC/TDMoIP IPmux-11

To apply the VLAN parameters:
1. Click Close.
A warning message may appear: “Changing the User VLAN Tagging may
disconnect Agent for 30 seconds”.
2. If a warning message appears, click OK.
The parameters are saved to the Agent.
Configuring the Static MAC Table
The Mac Table command enables you to manually configure Virtual (VLAN)
Bridged Local Area Networks, port-based VLANs (per IEEE 802.1Q), where VLAN
membership of a data frame is determined based upon the bridge port on which
the frame is received and the frame's destination MAC address. The mappings of
Received Bridge Ports and destination MAC Addresses to VLAN IDs are stored in
the Static MAC Table.

To configure the Static MAC Table:
• Select Configuration > MAC Table…
The Static MAC Table dialog box appears.
Figure 3-8. Static MAC Table Dialog Box
Table 3-6. Static MAC Table Parameters
Parameter Possible Values / Remarks
VLAN ID 1..4094
MAC Address The destination MAC address in a frame to which this entry's filtering
information applies
Received Bridge Port The port number of the port from which a frame must be received in order
for this entry's filtering information to apply
User1
User2
Network