System information

User's Manual Chapter 3 Configuration Management
RADview-SC/TDMoIP IPmux-11 Setting the System Parameters 3-9
Parameter Possible Values / Remarks
Network Port Yes, No
User 1 Port Yes, No
User 2 Port Yes, No
Bundle No
1
Manager No
IP Address
You have the following options:
• Add – Add a new VLAN
• Change – Change parameters of a VLAN
• Remove – Remove a VLAN
• Close – Apply VLAN Parameters and close the dialog box
• Refresh - Poll the device and display the latest values in the dialog box.

To add a new VLAN:
1. Click Add.
The Add VLAN dialog appears.
2. Configure the desired parameters.
3. Click Set.
The VLAN is added and the screen is refreshed.
• The Add button will be disabled if there are already 16 VLANs in the table.
• The VLAN ID must be different from any already in the table.

To change parameters of a VLAN:
1. Click the row of a VLAN, to select it.
2. Click Change.
The Change VLAN dialog appears.
3. Configure the desired parameters.
4. Click Set.
The VLAN parameters are changed.

To remove a VLAN:
1. Click the row of a VLAN to select it.
2. Click Remove.
A warning message appears: “Removing VLAN may disconnect the Agent
for 30 seconds“.
3. Click OK.
The VLAN is removed.
The Remove button is only enabled for disconnected VLANs; if the selected VLAN is
used by a bundle or a Manager, then the Remove button will be disabled.
Note
Note