- RAD IPmux-11 TDM Pseudowire Access Gateway Version 2.00 Installation and Operation Manual

Installation and Operation Manual Chapter 4 Configuration
IPmux-11 Ver. 2.00 Additional Tasks 4-33
Resetting IPmux-11 to the Defaults
You can reset IPmux-11 to its default settings. The reset to the defaults does not
affect the master clock setting. In addition, you can reset local IPmux-11 without
affecting its management parameters (IP address, mask and default gateway).

To reset IPmux-11 to the default settings:
1. From the System menu (
Figure 4-1), select Factory default.
2. From the Factory Default menu, perform one the following steps:
 Select All to reset all IPmux-11 parameters to the default settings.
 Select Except Management to reset all parameters, except for IP address,
mask and default gateway values.
IPmux-11 displays the following message:
Configuration will be lost and System will be reset.
Continue ??? (Y/N)
3. Type Y to confirm the reset.
IPmux-11 performs the requested type of reset.
Alternatively, you can reset IPmux-11 to the defaults by pressing the SET DEF
button on the rear panel.
Resetting IPmux-11
You can perform an overall reset of IPmux-11.

To reset IPmux-11:
1. From the Main menu, select Utilities.
The Utilities menu appears (see
Figure 4-36).
2. From the Utilities menu, select Reset.
A confirmation message appears.
3. Type Y to confirm the reset.
Utilities
1. File utilities >
2. Reset
>
Please select item <1 to 2>
ESC-prev.menu; !-main menu; &-exit 1 Mngr/s
Figure 4-36. Utilities Menu