- RAD IPmux-11 TDM Pseudowire Access Gateway Version 2.00 Installation and Operation Manual

Chapter 4 Configuration Installation and Operation Manual
4-24 Configuring IPmux-11 for Operation IPmux-11 Ver. 2.00
Configuration>Connection>Bundle connection
TDM channel ID: 1 Bundle ID: 1
1. Destination IP address ... (0.0.0.0)
2. Outbound label tagging (Enable)
3. Outbound tunnel label ... (4)
4. Outbound EXP bits ... 7
5. Inbound label tagging (Enable)
6. Inbound tunnel label ... (5)
7. Connection status (Enable)
8. Destination bundle ... (1)
9. Next hop type (IP)
10. Next hop IP address ... (0.0.0.0)
11. TDM bytes in frame(x48 bytes) ... (1)
12. Far end type (E1)
13. OAM connectivity (Disable)
14. Jitter buffer [msec][3 - 300] ... (300)
15. Sensitive (Data)
16. OOS mode (Tx OOS)
17. VLAN tagging (Enable)
18. VLAN ID[1 - 4095] ... (1)
19. VLAN priority[0 - 7] ... (7)
>
Please select item <1 to 19>
F - Forward Bundle ID; ? - Help
ESC-prev.menu; !-main menu; &-exit
Figure 4-22. Bundle Connection Menu when Connection Mode=TDMoIP CE, PSN Type=MPLS/ETH
Configuring the Ethernet Bridge
IPmux-11 contains an internal bridge where one of its ports is connected to a
TDMoIP interworking function, two external bridge ports are used as the user
ports, and the fourth is used as an Ethernet network port.

To configure Ethernet bridge:
1. From the Configuration menu, select Bridge.
The Bridge menu appears (
Figure 4-23).