- RAD IPmux-11 TDM Pseudowire Access Gateway Version 2.00 Installation and Operation Manual

Chapter 4 Configuration Installation and Operation Manual
4-10 Configuring IPmux-11 for Management IPmux-11 Ver. 2.00
 Enable (Telnet, SNMP or Web access is enabled)
 Disable (Telnet, SNMP or Web access is disabled)
 Manager Only (Access is allowed only for the stations appearing in the
manager list).
Table 4-1. Management Access Implementation
Who is Allowed to Access IPmux-11 Access Method Mode
Network
Manager(s)
Defined
Network
Manager(s) not
Defined
Enable Anybody Anybody
Disable Nobody Nobody
SNMP Access
Manager Only Only defined
network managers
Nobody
Enable Anybody Anybody
Disable Nobody Nobody
Telnet Access
Manager Only Only defined
network managers
Anybody
Enable Anybody Anybody
Disable Nobody Nobody
Web Access
Manager Only Only defined
network managers
Anybody
Configuration>System>Management>Management Access
1. User Access >
2. TELNET access > (Enable)
3. SNMP access > (Disable)
4. WEB access > (Enable)
>
ESC-prev.menu; !-main menu; &-exit 1 Mngr/s
Figure 4-10. Management Access Menu
Configuring Control Port Parameters
Configuration parameters of the IPmux-11 control port, except for the baud rate
are set at the factory and cannot be changed by the user (see
Figure 4-11). These
parameters have the following values:
• Data bits – 8
• Parity – None
• Stop bits – 1
• Flow control – None.