Specifications

Introduction 4-1

Chapter 4

Management via the CM-2

Module

The information presented in this chapter includes:

• CM-2 functions

• Description of supervision terminal hardware requirements, and of methods

for connecting a supervision terminal or network management station to

LRS-24

• Supervision terminal commands

• Supervision terminal operating instructions.

The instructions appearing in this chapter assume that the supervision terminal

operator is familiar with the configuration parameters of the modules installed in

LRS-24.

4.1 Introduction

This chapter describes how to use a supervision terminal to manage an LRS-24

enclosure that contains a CM-2 control logic module.

The CM-2 module also enables management of the LRS-24 system by means of a

RADview network management station, or other SNMP-based network

management station. For information regarding the use of the RADview network

management station, refer to the RADview User's Reference Manual.

CM-2 Module Capabilities

The CM-2 module includes an internal SNMP agent, and therefore it requires

preliminary configuration. The preliminary configuration of LRS-24 must always be

performed using a standard ASCII terminal connected to the CM-2 front panel

supervisory port, designated MANAGEMENT RS-232. You can use terminals of the

following types: VT-52, VT-100, TV-920, FREEDOM-100, FREEDOM-110,

FREEDOM-220, or other terminals that are fully compatible with one of these

terminals.

Order from: Cutter Networks

Ph:727-398-5252/Fax:727-397-9610