Specifications

FOMi-E1/T1 Quick Start Guide 1
Quick-Start Guide
If you are familiar with fiber optic modems, use this guide to prepare
FOMi-E1/T1 for operation.
QS.1 Installing FOMi-E1/T1
For most normal installations, setup of FOMi-E1/T1 should be performed in
the following order (see Chapters 2 and 3 for details of each procedure):
Warning
Make sure that the AC power cord is disconnected before removing the
unit's cover.
Jumper Setting
1. Remove the internal board.
2. Set Cable Type jumper as required (75Ω unbalanced for E1, 120Ω
balanced for E1 or 100Ω balanced for T1) (see section 2.4 for details).
3. Replace the board and close the unit.
Setup
1. Install the unit in a rack (optional, see Appendix A for details).
2. Disconnect the cables from the units.
Configuration via
Front Panel
1. Configure modem with remote modem details (see Chapter 3).
2. Connect the units to the DTEs.
3. Configure the DTE parameters.
4. Configure the Line parameters.
Alarms Check
Make sure that there are no alarms indicated on the LCD.
QS.2 Operating FOMi-E1/T1
Connections
1. Connect the fiber optic cables.
2. Connect the power cable.
FOMi-E1/T1 is turned on automatically upon connection to a power
source.
3. If there is an indication of a malfunction or fault, run the appropriate
tests (see Chapter 4).