Specifications

FOMi-E1/T1 Installation and Operation Manual Chapter 3. Operation
Operating Procedures 3-9
You will only be able to modify the configuration once the other party has
finished its modifications and:
•
a minute has passed since the other party finished and the system returns
back to STATUS, or
•
the other party scrolled out of LINE CONFIG.
Setting the Remote Modem (REM.M)
FOMi-E1/T1 allows you to select the mode of operation to fit to the remote
modem type. The available modems are designed for FOM-E1T1 (old
version), and NEW (FOMi-E1/T1). The NEW mode of operation supports the
management channel, while the FOM-E1T1 mode of operation does not
support the management channel. Therefore, in the FOM-E1T1 mode of
operation you cannot control or monitor the remote modem.
1. Press the CURSOR button to move to the Menu Type field.
2. Press the SCROLL button until LINE CONFIG is displayed.
3. Press the CURSOR button to move to the Parameters field.
4. Using the SCROLL button select the required mode of operation.
5. Press the ENTER button to set your choice (see Figure 3-7 and
Table 3-4 for LINE CONFIG menu Options).
LINE CONFIG
BITRATE
REM. M
INTRF
FO-INTRF
CABLE
TEST
REM. M:
NEW
FOME1T1
NEW
Figure 3-7 LINE CONFIG Menu: Configuring the Remote Modem
Configuring the
DTE
(DTE CONFIG)
The DTE CONFIG menu supports configuration of both local and remote
DTEs (see Table 3-5 and Figure 3-8 for menu options).
Table 3-5 DTE Config Menu Options
Menu Options Indicates Parameter Values Description
AIS
All "1" string is received
at the electrical
interface.
Enable
Disable
When an all "1" signal (AIS) is
detected at the optical or
electrical interface, the modem
transparently converts the
signal, and alerts the user via
front panel LEDs and the
supervisory port.