Specifications

FOMi-E1/T1 Installation & Operation Manual Chapter 2. Installation & Setup
Jumper Setting 2-3
120 E1 100 T1 75 E 1
Cable Type Jumper
Figure 2-1 FOMi-E1/T1 Stand Alone PCB Layout
➤
➤ ➤
➤ To return FOMi-E1/T1 to its case:
1. Insert the board firmly into the FOMi-E1/T1 case.
2. Insert the FOMi-E1/T1 top cover by pushing it straight down.
3. Insert and tighten the four cover screws.
Connecting the
Interfaces
Figures 2-3 and 2-4 show the rear panel of a standard version FOMi-E1/T1
unit and identify connector locations for the AC and DC versions,
respectively.