Specifications

Quick Start Guide Installation and Operation Manual
2 Operating FOM-E3 and FOM-T3 FOM-E3, FOM-T3 Ver. 1.0
Connecting the Cables
 To connect the cables:
1. Connect the E3 or T3 electrical interface.
2. Connect the fiber optic interface.
3. Connect the power cable (first to the modem, then to the mains supply).
Operation starts when the power is applied to the rear panel power
connector.
2. Operating FOM-E3 and FOM-T3
1. Check that the TEST switch is set to the NORM position.
2. Verify LED status. All the LED indicators should be OFF, except for the PWR
indicator.
3. If there is an indication of a malfunction or fault, run a diagnostic test.