Specifications

Installation and Operation Manual Chapter 2 Installation and Setup

RICi-E3, RICi-T3 Ver. 1.0 Connecting to the ASCII Terminal 2-3

2.4 Connecting the Interface Cables

Figure 2-1

illustrates the rear panel of a typical RICi-T3 unit. The RICi-E3 unit is

xsimilar, except for an E3 interface instead of the T3 interface.

Appendix A

specifies the RICi-E3, RICi-T3 connector pinouts.

10 /1 00B aseT

LINK ACT

CONT ROL

48/60VDC~100-240VAC/

RX TX

Figure 2-1. RICi-T3 Rear Panel

 To connect the Ethernet interface:

• Connect the user LAN to the RJ-45 connector designated 10/100 BaseT.

 To connect the E3 or T3 interface:

1. Connect the Rx cable to the BNC connector designated Rx.

2. Connect the Tx cable to the BNC connector designated Tx.

2.5 Connecting to the ASCII Terminal

You may connect RICi-E3, RICi-T3 to an ASCII terminal using the 9-pin D-type

female CONTROL connector at the rear panel. Refer to

Appendix A

for the

connector pinout.

 To connect the ASCII terminal to the CONTROL port:

1. Connect the male 9-pin D-type connector of the CBL-DB9F-DB9M-STR Control

Port cable to the connector labeled CONTROL.

2. Connect the other end of this cable to an ASCII terminal.