User guide

5-1
5. GS-700 Imaging
Densitometer
Fig. 5-1. GS-700 Imaging Densitometer
Before you can begin scanning images with the GS-700 Imaging
Densitometer
®
, your instrument must be properly installed and connected
with the host computer. See the hardware manual for installation, startup,
and operating instructions.
PC Only: A Note About SCSI Cards
The GS-700 is connected to your computer by a Small Computer System
Interface (SCSI) cable. To use the GS-700, you must have a SCSI card installed
in your PC. If you have an older PC, you may also need to load the SCSI and
WinASPI drivers that came with your card.
Simulation Mode
Any of the imaging device acquisition windows can be opened in “simulation
mode.” In this mode, an acquisition window will open and the controls will