User guide

Quantity One User Guide

15-6

be the descriptive name of the standards. You can change the name by typing

in the text box next to the Standards prompt.

You can enter additional information next to the Comment prompt. The

<category> buttons and ﬁelds can be used to further deﬁne your standards.

Entering Standard Values

If you are creating new standards, you must enter the values of your standard

bands in the table in the middle of the form. Predeﬁned standards will

already have these values entered.

Fig. 15-6. Entering the values of your standards.

The table has three columns, labeled Type, Name, and the units you

previously selected (e.g., KDa, pI, Rf). In the units column, type a value for

the ﬁrst standard band and press the Return key. The cursor will skip to the

ﬁeld below, and you can enter a value for the second standard band. Repeat

this process until all your standard values have been entered.

Note: The values do not need to be entered sequentially. They will

automatically sort themselves in ascending or descending order,

depending on how you speciﬁed the units.

You can enter a name for each standard band in the Name column. This will

appear in subsequent reports and printouts.

Name of the

standard

Standard value

Click here to delete

this value and

renumber the

remaining standards